If your dishwasher isn’t drying dishes, it could be a problem. Today we find for you solution how to repair Dishwasher Carrier MDWFS014LSO.
Most common issue could be high-limit thermostat. You must check it. The high-limit thermostat is a safety device that prevents your dishwasher’s heating element from getting too hot. If it malfunctions, however, it can shut the heating element off before the dishes are dry.
You’ll need your multitester for this procedure, set to the lowest ohms setting, as well as an assistant aiming a flashlight towards your work area. Before getting started, unplug the dishwasher and then remove the bottom panel by unscrewing it screwdriver. Look inside the access area underneath the dishwasher tub for the high-limit thermostat—a silvery disk roughly the size of a quarter towards the right side of the tub. Slip off the two wires connected to it, and then unclip the thermostat, or use your screwdriver to remove the screws holding it in place, and remove the thermostat from the dishwasher.
Touch the two probes of the multitester to the terminals on the high-limit thermostat. While at room temperature, the reading should be at infinite resistance. Now, hold the thermostat near a hot lightbulb or space heater and check the readings again. The needle should now show zero. If you get some other readings, your high-limit thermostat is faulty and needs to be replaced. If this doesn't work, there could be a defective part that requires a replacement, and you may need to consult a professional.
Post Gallery
