One of the most comfortable appliances at home is a dishwasher. Modern dishwashers have many programs, timers etc. It’s a real problem when you know that something is wrong with the dishwasher, like not filling up. We will help you to fix a problem with the dishwasher KitchenAid kdtm404kps. Most common solution for this problem - is to change the float switch. When the overfill float switch detects that the water level is too high, it shuts off power to the water inlet valve, stopping the flow of water into the tub. Our instruction will help you to replace the float switch.
Unplug the dishwasher or shut off the house circuit breaker for the dishwasher. With the dishwasher door open, remove the Torx screws from the inner door panel. Support the outer door panel with one hand as you remove the final 2 screws so the outer door panel doesn't fall. Separate the outer door panel and control panel slightly from the inner door panel, and rest the outer panel on the floor while you disconnect the user interface control wire harness from the control panel.Pull off the outer door panel and control panel.Using a nut driver, remove the screws that hold the bottom front access panel and toe panel in place. Pull the access panel and the toe panel forward and remove them. Release the left locking tab on the overfill float switch housing and open the left side cover. Unplug the wire harness from the connector. Release the right locking tab on the float switch housing and open the right side cover. Remove the overfill float switch. Insert the new overfill float switch and close the right side cover. Plug in the wire harness. Close the left side cover. Position the toe panel on the dishwasher and then position the access panel in front of the toe panel. Insert the mounting screws and tighten the screws firmly. Position the outer door panel and control panel close enough to the inner door so you can reconnect the user interface control wire harness. Reconnect the user interface control wire harness and attach the outer door panel and control panel to the inner door panel. Reinstall the mounting screws. Reset the house circuit breaker or plug in the dishwasher to restore electrical power.
Now it fixed! Need help? Don’t hesitate to contact our customer support and arrange a meeting!