GE dryer needs to replace bearing kits for drum

The dryer has many advantages over the washer with drying functions. It is worth using this appliance at least once, and you won’t return to previous life. The tumble dryer allows you to dry items from a wide variety of fabrics. Modern technology is able to determine the moisture level itself and, when the set values ​​are reached, stop the drying process or, if it is not working properly, when the dryer does not drain the water. As a result, the laundry never overdries, it remains soft and pleasant to the touch without the use of special conditioners and other chemicals. The dryer can even freshen up and clean rugs, blankets, toys, blankets and pillows. The dryer allows you to dry things in several modes. When ironing, the laundry remains slightly damp, which makes subsequent ironing easier. If you do not want to iron your linen, select the mode which allows you to wear clothes without ironing. Things will be completely ready to use. If your GE dryer is noisy and refuses to work properly, drum bearings might be faulty. As with any repair, be sure you unplug the appliance before beginning. Your first step is to remove the screws at the rear of the control panel to release it. Next, open the dryer door and remove the screws inside the door frame which secure the main top. Now carefully slide the main top forward, unhook it from the control panel tabs and remove. Uninstall the screws securing the front panel. Now, lift the front panel up and rotate it to the side. If applicable to your model, remove the light bulb. Detach the slide bearing tabs from the front panel and gently pull the old slide bearing assembly away from the front bulkhead. Prepare the new drum slide bearing for installation by first removing the plug from the light bulb access hole if required and installing new drum slides. Install the new bearing assembly by inserting the lower tabs into the bulkhead and snapping the assembly into place. Reinstall the light bulb if applicable. Reposition the front panel by first inserting the tabs in the base with the slots in the panel. Now lift up the drum and snap the front panel into place. Secure the screws. Replace the main top by inserting the control panel tabs into the slots at the back of the main top. Fully position then replace the screws. Secure the control panel with the screws in the back. You’re now ready to plug the power cord back in and confirm that the appliance is functioning properly.