Loud noises from your dryer could be created by many issues. One of the most common solutions for loud noise is to change drum rollers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. To determine if the rollers are worn out, inspect the rollers. If one or more of the rollers are severely worn, we recommend replacing all of the rollers at the same time as a preventative measure. We have for you a simple 10 steps guide for replacing drum rollers in Kenmore 110 or similar models. Let’s start.
- Shutting off the power and wearing protective gloves.
- Pull the lint screen out of the housing in the top panel of the dryer. Use a Phillips screwdriver to remove the 2 screws that secure the lint screen housing to the top panel. To release the clips that lock the top of the dryer in place, push a putty knife under the lid near the left and right edges of the front of the dryer. Lift the top and prop it securely against the wall behind the dryer.
- Use a slot screwdriver to release the locking tab on the wire harness plug for the door switch. Disconnect the wire harness. Use a 5/16-inch nut driver to remove the front panel mounting screws from the inside of the cabinet. Pull the front panel forward slightly, and then lift and unhook it from the 2 bottom hangers. Pull the front panel off of the dryer and set it aside.
- Note the configuration of the belt on the idler pulley and the motor pulley before removing it—take a digital picture of it so you know how to reinstall it. Push the idler pulley to the right to release tension on the drive belt. Pull the drive belt off of the idler pulley and the motor pulley. Pull the drum out of the dryer and set it aside.
- Use a slot screwdriver to pry the triangular washer off the front of the drum support roller. Pull the drum support roller off of the front of the shaft.
- Push the new drum support roller onto the shaft and secure it with the triangular washer.
- Place the rear of the drum on top of the support roller that's on the rear panel inside the dryer cabinet. Lift the front of the drum to access the drive motor and idler pulley. Referring to the digital picture of the configuration, thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley.
- Position the front panel on the hangers at the bottom of the cabinet. Line up the mounting holes and reinstall the screws in the top of the front panel to secure it to the dryer cabinet. Plug the wire harness back into the plug on the door switch. Make sure the locking tab engages properly.
- Lower the top panel and snap it into place. Reinstall the screws in the lint duct housing and reinstall the lint screen.
- Plug the dryer into the wall outlet. If it's a gas dryer, turn on the gas supply to the dryer.
Problem with loud noises is solved! Make some tests. If you need help - don’t hesitate to contact our customer support and arrange a meeting!
