KitchenAid dishwashers are able to operate for many years without any troubles. Unfortunately, one day any appliance can break or lose its efficiency due to various reasons. When your dishwasher isn’t starting/filling because the control board is stuck and "Clean" light blinking, the manual will detect a problem with the heating element. If your dishwasher does not fill, then you should first check the inlet supply to verify that you have enough water pressure. Reset the control board through diagnostic test mode. If it helps and the water heater works, there is nothing to worry about. Unless it helps, unplug your dishwasher and disconnect the water supply before starting. Locate your water inlet valve. It is commonly found on the lower left side of your dishwasher. You likely will need to remove the lower access panel to locate it. If your valve shows signs of damage, wear, or cracking, visually inspect the water inlet valve. It can probably need a replacement. Contact our technical assistance and we’ll provide a quick help!
November 26, 2023
AC is leaking from the coil – HVAC Troubleshooting in San Diego
Have you encountered a leaking air conditioner? This causes not the most pleasant feelings and deprives you of comfort. Before solving this problem, you should determine what exactly became the source of the air conditioner flow.
