It’s difficult to imagine life without such an appliance as a refrigerator. When it stops working, or won’t running you need to fix it immediately. Today we will talk about the problem with running in Sub-Zero 561. Fortunately the solution is simple, and you can fix it at home without any help. You just need to replace the compressor start relay. This process don’t take much time. Before you started, you need to prepare some tools: work gloves, nut driver set, slot screwdriver, manufacturers approved start relay. Let’s begin.
Unplug the power cord from the wall outlet. Pull the refrigerator away from the wall. Remove the screws from the rear compartment cover and then remove the cover. Pry off the wire retainer holding the start relay on the compressor. Disconnect the wire harness from the start relay. Pull the start relay and run capacitor off the compressor. Transfer the run capacitor from the old start relay to the new start relay. Plug the new start relay with capacitor into the compressor terminals. Plug the wire harness into the new start relay. Reinstall the wire retainer to hold the start relay on the compressor. Position the rear compartment cover on the back of the refrigerator and reinstall the mounting screws. Plug in the refrigerator and push the refrigerator back into place.
Here we are! After this repair, the refrigerator must starting without any problems. Make some tests! Need help? You can contact our customer support team and arrange an appointment at the convenient time.